Produk Selesaiview
Bar's Leaks Head Gasket and Cooling Sealant is designed to repair blown head and intake gasket leaks. It also seals cracked cylinder heads and blocks, stops heater core and radiator leaks, and fixes leaking freeze and core plugs. This product is formulated to provide a permanent seal for various cooling system issues.
Image: The Bar's Leaks HG-1 HEAD SEAL product bottle and its retail packaging, showcasing the product name and key features.
Fitur Utama
- Repairs blown head and intake gasket leaks.
- Seals warped or cracked cylinder heads and engine blocks.
- Stops heater core and radiator leaks.
- Fixes leaking freeze and core plugs.
- Compatible with all types of 50-50 mix coolants (yellow, orange, pink, red, blue, green silicate-based & non-silicate based OAT/HOAT) and water.
- No flushing or thermostat removal required.
- Reinforced with carbon fibers for a strong, permanent seal.
- Suitable for all gasoline and diesel engines, including racing applications.
Image: A close-up of an engine block with a head gasket, illustrating the product's function in repairing gasket leaks.
Image: A hand pouring green coolant into a vehicle's radiator, emphasizing the product's compatibility with various coolants and no-flush requirement.
Gambar: Detail view of an engine cylinder head, highlighting the product's ability to seal warped or cracked components.
Informasi Keselamatan Penting
WARNING: HEAD SEAL™ Blown Head Gasket Repair is designed to stop cooling system leaks. DO NOT add to engine oil. If at any time engine overheats, turn vehicle off and allow engine to cool.
DANGER: Opening the cooling system while the engine is hot or running may cause severe burns.
NOTE: Cooling systems that are dirty or partially clogged should be flushed before usage.
Peringatan Proposisi 65:
Produk ini mengandung bahan kimia yang diketahui oleh Negara Bagian California dapat menyebabkan kanker dan cacat lahir atau bahaya reproduksi lainnya.
PERINGATAN:
Skin & Eye Irritant. Read instructions and warnings on the product label carefully.
PROTECT FROM FREEZING.
Ketentuan Aplikasi
This solution is suitable for vehicles that can idle for 15 minutes without overheating or requiring additional coolant.
Works with all gasoline and diesel engines.
Compatible with all types of 50-50 mix coolants, including yellow, orange, pink, red, blue, and green silicate-based & non-silicate based (OAT / HOAT) antifreeze, and water.
No draining or thermostat removal is required.
Bagan Dosis
| Kapasitas Sistem Pendingin | Jumlah Produk |
|---|---|
| 2.5 gallons (10 quarts) to 5 gallons (20 quarts) | Use 1/2 Bottle for systems from 1.5 gallons (6 quarts) to 2.49 gallons (9.9 quarts) |
| For larger systems, use 1 bottle for every 5 gallons | 1 bottle for every 5 gallons |
Note: The dosage chart is based on information from the product label. Always refer to the physical product for exact measurements.
Petunjuk Aplikasi
- Install only in a cold engine. Shake bottle well. Remove radiator cap and pour the correct amount of product in per the dosage chart. Fill radiator and reservoir/overflow tank to proper level and reinstall radiator cap. TIP: Radiator cap may be on top of radiator, on engine, or on one of the two pressurized reservoir overflow tank.
- Turn heater on hot and fan on high. Run engine until thermostat opens or normal operating temperature is reached. Turn vehicle off and allow engine to cool. This may take 30 minutes or longer.
- Top off radiator (add coolant as needed) and either run engine at high idle (approximately 1200 RPM) for vehicles with a tachometer or gently drive vehicle for 15 minutes. Turn vehicle off and allow engine to cool.
- Top off radiator and leave Bar's Leaks HEAD SEAL Blown Head Gasket Repair in system for continued protection. Drive vehicle as normal. Most leaks seal instantly, but some can take additional thermocycles which happen over a few days of usage.
Image: The back label of the Bar's Leaks HG-1 bottle, displaying the full application instructions and dosage chart.
Penyelesaian Masalah
- If the leak persists after following the instructions, ensure the cooling system is clean and not partially clogged. A dirty system may hinder the product's effectiveness.
- For severe leaks or persistent issues, a second application may be considered after allowing the first application to fully circulate and set over a few days.
- If the engine overheats during application, immediately turn off the vehicle and allow it to cool completely before proceeding.
- This product is designed for coolant-related leaks. It is not intended for engine oil leaks.
Spesifikasi
- Nomor Model: HG-1
- Merek: Bar's Leaks
- Dimensi Produk: 9.78x3.22x3.22 inci
- Berat Barang: 2.5 pon
- Warna: Gray (bottle)
- UPC-nya: 046087011362
- Pabrikan: Bar's Leaks
- Tanggal Pertama Tersedia: 7 Juli 2004
Informasi Garansi
Produk ini dilengkapi dengan Garansi Seumur Hidup Terbatas.
The warranty covers product effectiveness in sealing head gasket coolant problems when applied correctly.
For warranty claims or further details, refer to the product packaging or contact Bar's Leaks customer support.
Image: Product packaging indicating the "Limited Lifetime Warranty" for the Bar's Leaks HG-1 HEAD SEAL.
Dukungan dan Kontak
For questions or comments regarding Bar's Leaks products, please contact the manufacturer directly.
Pabrikan: Bar's Leaks
Weblokasi: www.barsleaks.com
Telepon: (800) 345-6572 (9 AM - 5 PM Mon-Fri EST)