Westek TMDCD60 Hardwire Indoor Countdown 6-Setting Wall Switch Timer User Manual

Perkenalan

The Westek TMDCD60 is a hardwire indoor countdown timer designed to replace a standard wall switch. It provides timed control for lights, fans, heaters, and other devices, automatically turning them off after a selected duration. This manual provides instructions for safe installation, operation, and maintenance of your timer switch.

Informasi Keselamatan

PERINGATAN: Risiko Sengatan Listrik. Improper installation can lead to serious injury or death. Always turn off power at the circuit breaker or fuse box before beginning installation. Consult a qualified electrician if you are unsure about any part of the installation process.

• Perangkat ini hanya untuk penggunaan di dalam ruangan.
• Pastikan semua sambungan kabel aman dan mematuhi kode kelistrikan setempat.
• Jangan melebihi batas daya listrik perangkat.
• A neutral wire is required for installation. Older homes may not have a neutral wire in the switch box.

Isi Paket

• Westek TMDCD60 Countdown Timer Switch
• Instruksi Manual (dokumen ini)

Produk Selesaiview

The Westek TMDCD60 timer switch features a single push-button control and LED indicators for selected time settings. It is designed to fit into a standard wall switch box and can be used with a standard rocker wallplate (not included).

Gambar 1: Depan view of the TMDCD60 timer switch. The face includes a single control button and five LED indicators labeled "10 MIN", "20 MIN", "30 MIN", "60 MIN", and "HOLD".

Instalasi

1. Matikan Daya: Locate the circuit breaker or fuse that controls the switch you are replacing. Turn off the power completely before proceeding. Verify power is off using a voltage penguji.
2. Hapus Sakelar yang Ada: Carefully remove the wallplate and unscrew the existing switch from the wall box. Disconnect the wires from the old switch. Note the connections for reference.
3. Identifikasi Kabel: The Westek TMDCD60 timer requires four wires:
   • Kabel Hitam: Saluran Telepon Panas
   • Kabel Merah: Load (to the device being controlled)
   • Kawat Putih: Netral
   • Kawat Hijau: Tanah

   Ensure your wall box contains a neutral wire. If not, this timer cannot be installed without running a new neutral wire, which should be done by a qualified electrician.

   

   Gambar 2: Kembali view of the TMDCD60, illustrating the labeled wires for proper connection.
4. Hubungkan Kabel: Using wire nuts (not included), connect the wires from the wall box to the corresponding wires on the TMDCD60 timer switch:
   • Hubungkan Hitam kabel dari timer ke Saluran Telepon Panas wire from the wall box.
   • Hubungkan Merah kabel dari timer ke Memuat wire from the wall box (to the light/fan).
   • Hubungkan Putih kabel dari timer ke Netral wire from the wall box.
   • Hubungkan Hijau kabel dari timer ke Tanah wire from the wall box.
5. Pasang Timer: Carefully fold the wires into the wall box. The timer is deeper than a standard switch, so ensure there is enough space. Secure the timer switch to the wall box using the provided screws.
6. Pasang Pelat Dinding: Attach a standard rocker wallplate (not included) over the timer switch.
7. Pulihkan Daya: Nyalakan kembali daya pada pemutus arus atau kotak sekering.

Operasi

The TMDCD60 timer operates with a single push-button control. Each press cycles through the available countdown settings and the HOLD function.

1. Turning On and Setting Timer: Press the control button once to activate the timer. The timer will cycle through the following settings with each subsequent press:
   • OFF (no LED lit)
   • 10 Minutes (10 MIN LED lights up)
   • 20 Minutes (20 MIN LED lights up)
   • 30 Minutes (30 MIN LED lights up)
   • 60 Minutes (60 MIN LED lights up)
   • HOLD (HOLD LED lights up)

   The connected device will remain on for the selected duration and then automatically turn off. The corresponding LED will indicate the active setting.

2. Fungsi HOLD: To keep the connected device on indefinitely, press and hold the control button for approximately one second until the "HOLD" LED illuminates. In HOLD mode, the device will remain on until you press the button again to turn it off or select a countdown setting.
3. Mematikan: To turn off the connected device before the countdown finishes or while in HOLD mode, press the control button until no LEDs are lit.

Pemeliharaan

The Westek TMDCD60 timer switch requires minimal maintenance. To clean the surface, wipe with a soft, damp kain. Jangan gunakan pembersih atau pelarut abrasif. Pastikan daya dimatikan sebelum membersihkan.

Penyelesaian Masalah

Spesifikasi

• Model: TMDCD60
• Merek: Bahasa Inggris Barat
• Warna: Putih
• Masukan Voltage: 120V AC, 60Hz
• Beban Maksimum: 15A Resistive, 1000W Tungsten, 500VA Ballast, 1/4 HP Motor
• Pengaturan Timer: 10, 20, 30, 60 minutes, HOLD
• Ukuran: 1"D x 1"W x 1"H (Note: These dimensions typically refer to packaging; the device itself is deeper for in-wall installation.)
• Berat Barang: 4.48 ons
• Tipe Pemasangan: Dinding
• Beralih Gaya: Sakelar Rocker
• Kabel Netral: Diperlukan

Garansi dan Dukungan

This Westek product is covered by a Garansi terbatas 1 tahun sejak tanggal pembelian. Garansi ini mencakup cacat bahan dan pengerjaan dalam penggunaan normal.

For technical support or warranty claims, please contact Westek customer service. You can find more information and contact details on the official Westek websitus atau dengan mengunjungi Westek Store on Amazon.